Zoe's (Rostock Max V2) Enclosure

drwho · Post by **drwho** » Sun Apr 19, 2015 10:45 pm

We just finished the enclosure for our Rostock Max V2. Her name is Zoe

Thanks to @JFettig for the design work it turned out well.

JFettig · Post by **JFettig** » Mon Apr 20, 2015 10:44 pm

Looks good

3D-Print · Post by **3D-Print** » Mon Apr 20, 2015 10:52 pm

Looks awesome!!

drwho · Post by **drwho** » Fri Apr 24, 2015 4:53 pm

BenTheRighteous · Post by **BenTheRighteous** » Fri Apr 24, 2015 5:02 pm

Boy, JFettig's enclosure sure is popular!

That reminds me, I have to go dig up that thread to make a suggestion...

drwho, you should consider swapping out the blue LCD for a yellow one. That would look sliiiiiick next to those yellow brackets!

CRPerryJr · Post by **CRPerryJr** » Sun Apr 26, 2015 1:06 am

Did you have any difficulties printing the X.stl file? That seems to be the one file I can't get to print.

drwho · Post by **drwho** » Thu Apr 30, 2015 11:35 pm

CRPerry Jr. No trouble with printing the X.stl file. What issue is it giving you?

CRPerryJr · Post by **CRPerryJr** » Fri May 01, 2015 6:09 am

Ny issue printing the x.stl file was the z-lift. it was set to low at default. I received recommendations to raise it to 1 mm, which did the trick!

drwho · Post by **drwho** » Fri May 01, 2015 11:02 am

What layer height are you using?

The majority of our pieces are printed at .4 mm height.

Welcome to the SeeMeCNC Community