Welcome to the SeeMeCNC Community

Hi guys, Recently I got to work fixing my v2 and wasn't too careful when install the base top plate when i got engaged in an all out war with the t nut which just wouldn't let go P_20200510_215532.jpg In hindsight I should've just taken the entire plate out before trying to unscrew the heated bed ...

Yeah, I was playing around with the z height but wasn't sure if it was the same value that the controller modifies or if there are any side effects.

Now that I know, though, will try it for real. Thank you Jimustanguitar!

Hi guys, I was wondering if it was possible to set the z height without the LCD controller. My controller is broken and G0 will not go below 0 so I figured I have to modify the values in the eeprom. Which value(s) should I modify? Is it OK to change the z height? What about the z probe? Many thanks!

Hi guys, So I haven't had much luck recently.. Was replacing my spoiled thermistor, soldered the legs to AWG22 and did the whole JST pins thing (quick disconnect setup). In my haste to get it up and running I left the soldered portion unshielded while trying to place the thermistor (with RTV) in ...

Hi, I recently replaced my thermistor after accidentally dislodging it. It worked fine (temp roughly the same as bed), PID autotune also worked too (changed the values slightly). After autotune, the temps started showing def for both nozzle and bed, and after restarting the printer a few times the ...

Hi, I've replaced the hotend thermistor with one taht has similar specs to this http://reprap.org/wiki/Thermistor#RRRF_100K_Thermistor Only difference is the beta value is 4000 Question: Can i simply replace USER_THERMISTORTABLE0 with the values from the RepRep wiki and GENERIC_THERM1_BETA with the ...

ok.. thanks guys. I shall just buy the exact same thermistor to replace it!

Hi guys, My thermistor pulled out of the hot end (don't ask how, i was a little rough) So i got these thermistors from a local electronics supplier http://www.sgbotic.com/index.php?dispatch=products.view&product_id=1202 Replacement thermistor datasheet http://www.sgbotic.com/products/datasheets ...

check your LCD header. I got mine inserted wrongly (B header) and it gave me the same error. Once i plugged it correctly the error went away

Have you solved the sd card issue?

I had the same problem. got the sd card init error. It was caused by plugging the LCD header (B) the wrong way. Once i inserted it correctly everything worked.

thanks guys!

i shall try it out first. let's hope it works!

Hi guys, so I'm about to install my hotend onto the printer but i have this nagging feeling that the RTV was not applied properly. Should i remove the resistors and reapply (with new resistors) ? The sillicone seems to be holding them really tightly [img]https://lh3.googleusercontent.com ...

Thanks Brian and Jim!

I'm still a bit unsure, what is the right way to install the t-nut. Should the prongs be bent when the screw is fully installed or should the prongs be straight?

So i wasn't careful when screwing in the belt clamp holders and this is what my inside plate looks like now (the prongs on the t-nuts got bent and dug into the melamine - i was using a battery operated screwdriver) [img]https://lh5.googleusercontent.com/-IOWjVEYct4s/VCA2dpMnLTI/AAAAAAAAJqY/I ...

Hi all!

Big hello from Singapore! Just got Rostock Max v2 kit a few days ago and am halfway done with fixing it up. Can't wait to try my first print!

yeah, i'm stuck at this part too. not sure what to do with the green wire.