Errors at end of print

[forrie]

Hello - I've been playing around with Kiss and have getting some good results but have this annoying bug in Repetier-Host.

At the end of the print the nozzle freezes at the finishing point and I get error codes similar to the below lines, over and over again. The arm's won't reset to a home position, nor will the heaters turn off. Can anybody share their postfix GCode perhaps? or do you think it could be something else?

Code: Select all

Error: expected line 31777 got 31789
Resend: 31777

I've looked at that line in the code, but it doesn't make sense as it's only 1/4 of the way through the file (print actually finishes).

I'm currently using:

Code: Select all

G1 X70 Y0 F5000
G28

Slicer and Cura behave themselves at the end of the print....just can't figure this one out...

[McSlappy]

I had the same issue, turned out I was missing a ";" in the post gcode in kisslicer. Check those bits of code and paste what you have.

[forrie]

You are correct! I had a line without a ;

All working now...Thanks!

[Eaglezsoar]

Does anyone have an idea what causes the line to be missing the ;?
A bug in the software?

[Polygonhell]

It's probably a typo in the default config.

Repetier is a lot pickier about GCode formatting than some of the other firmwares, so it might not cause an issue on what ever Jonathan is testing on these days.

[Eaglezsoar]

It's probably a typo in the default config.

Repetier is a lot pickier about GCode formatting than some of the other firmwares, so it might not cause an issue on what ever Jonathan is testing on these days.

Good point, thanks.

[forrie]

I think I had a blank line at the bottom of the prefix screen...