Greetings
Posted: Wed Feb 05, 2014 9:38 pm
I'm a chopper riding IT Guy.
Been out of the DIY stuff for a long time but getting back into it ,electronics - raspberry pi, arduino, 3d printing Rostock Max, looking to add a laser cutter to the selection of toys next along with some welding equipment.
I'm doing my first test print as I enter this.
I think I have a little too much drag on the paper when I did the calibration, might have to back and tweak it a little lighter.
Also ordered a 3D Doodler pen for myself the other day. I think it will be usefull in plastic welding piece that are too big to make in one shot in my Rostock.
Been out of the DIY stuff for a long time but getting back into it ,electronics - raspberry pi, arduino, 3d printing Rostock Max, looking to add a laser cutter to the selection of toys next along with some welding equipment.
I'm doing my first test print as I enter this.
I think I have a little too much drag on the paper when I did the calibration, might have to back and tweak it a little lighter.
Also ordered a 3D Doodler pen for myself the other day. I think it will be usefull in plastic welding piece that are too big to make in one shot in my Rostock.
