I'm a chopper riding IT Guy.
Been out of the DIY stuff for a long time but getting back into it ,electronics - raspberry pi, arduino, 3d printing Rostock Max, looking to add a laser cutter to the selection of toys next along with some welding equipment.
I'm doing my first test print as I enter this.
I think I have a little too much drag on the paper when I did the calibration, might have to back and tweak it a little lighter.
Also ordered a 3D Doodler pen for myself the other day. I think it will be usefull in plastic welding piece that are too big to make in one shot in my Rostock.
Greetings
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Greetings
Welcome to the Forum!
You sound like you have a lot on your plate. It also sounds like you could contribute a lot to the forum.
We are here to help in any way we can so if you have a question or want to answer a question that's
what we are here for.
Happy printing, if you find the time!
You sound like you have a lot on your plate. It also sounds like you could contribute a lot to the forum.
We are here to help in any way we can so if you have a question or want to answer a question that's
what we are here for.
Happy printing, if you find the time!