KISSlicer Settings for Calibration Pyramid

[inventabuild]

I am trying to fine tune my RMAX's print quality using KISSlicer and the following pyramid:

http://www.thingiverse.com/thing:29429

[img]http://imageshack.us/scaled/thumb/823/tnm2.jpg[/img]

I'm using a j-head from here:
http://reprap.me/epages/reprap_nu_41490 ... -Head-0001

And I'm using white PLA and would like to create fine quality prints. Everyone please chime in and let me know if you have any suggestions to modify my KISSlicer settings which are as follows:

KISSlicer Style Tab:
[img]http://imageshack.us/scaled/thumb/594/vyfe.jpg[/img]

KISSlicer Material Tab:
[img]http://imageshack.us/scaled/thumb/18/jvum.jpg[/img]

KISSlicer Printer/Hardware Tab:
[img]http://imageshack.us/scaled/thumb/856/vnl.jpg[/img]

KISSlicer Printer/Firmware Tab:
[img]http://imageshack.us/scaled/thumb/16/48wg.jpg[/img]

KISSlicer Printer/Extruders Tab:
[img]http://imageshack.us/scaled/thumb/22/h4ew.jpg[/img]

KISSlicer Printer/Speed Tab:
[img]http://imageshack.us/scaled/thumb/825/8nhf.jpg[/img]

KiSSlicer Setting Level (Lower Right of Screen):
[img]http://imageshack.us/scaled/thumb/850/3l.jpg[/img]

I realize settings can vary depending on a lot of things, but I would like to find a good baseline to start from and have not found anything on the Forum that covers a good starting point for all the settings in KISSlicer like I posted here. Any suggestions are appreciated. Thank you.

[Eaglezsoar]

Did you see the Kisslicer sub-forum? See here http://forum.seemecnc.com/viewtopic.php?f=15&t=1452

The files Mhackney generously supplied should give you something to work with.

[inventabuild]

Awesome. Thank you Eaglezsoar.