Greetings!

Introduce yourself to the community!
Post Reply
mandalarose
Plasticator
Posts: 9
Joined: Sat Nov 05, 2016 1:24 pm

Greetings!

Post by mandalarose »

Greetings all! Just got my Rostock v3 on Friday.

Had some challenges, but so far, loving it. Print quality is fantastic.

Still need to figure out how to calibrate it a bit tho. Did a 20mm cube, and am getting 19mm cube instead.

Cheers!
Wade
Top
Zesty_Lykle
Printmaster!
Posts: 60
Joined: Thu Oct 27, 2016 2:45 pm
Location: Cyrpus
Contact:
Contact Zesty_Lykle

Re: Greetings!

Post by Zesty_Lykle »

Hi Wade,
Welcome from another newbie here.
So far so good. :-)

Lykle
Lykle
Design life, and enjoy.
Top
Post Reply

Return to “New Member introduction”