Page 6 of 6
Re: EZ Probe Attachment for Rostock MAX
Posted: Thu Feb 20, 2014 5:42 pm
by geneb
Once you've got it calibrated, you're good to go. Hell, John throws them in the back seat of his car, etc. and they don't lose calibration. Once you set it, you can (for the most part), forget it.
Stick it on a desk and let it run - just keep it out of drafts.
g.
Re: EZ Probe Attachment for Rostock MAX
Posted: Thu Feb 20, 2014 5:46 pm
by Chrissi
Yes, I wonder about drafts, I added the little 30mm blower and duct and things leaned away from it so ordered two more fans, maybe cut back on the wind to 50% and even it out?
Two roll of ABS coming from local source. I detect a whole new level of misery for a few days.
Re: EZ Probe Attachment for Rostock MAX
Posted: Thu Feb 20, 2014 5:50 pm
by geneb
If you're printing ABS, you cannot use fans. Layer fans should only be used with PLA.
g.
Re: EZ Probe Attachment for Rostock MAX
Posted: Thu Feb 20, 2014 8:08 pm
by Chrissi
Yes, I understand that one thanks though. No, the fans are just to help fine tune some of the PLA stuff.