Hi, I have just started using my Eris. I have a Rostock V2 as well. After my first two prints (the calibration box and a small camera mount for a quadcopter) the Eris z height raised so the PLA barely lays down on the glass. I have run the calibration multiple times but it doesnt seem to help. Should I just increase the z_max in the eprom by .1mm until its better? Or is there another issue/fix?
Thanks!
Issue with z height?
-
bvandiepenbos
- Printmaster!
- Posts: 923
- Joined: Thu Apr 05, 2012 11:25 pm
- Location: Goshen, IN
- Contact:
Re: Issue with z height?
You should be probing with it cold.
~*Brian V.
RostockMAX v2 (Stock)
MAX METAL "ShortyMAX"
MAX METAL Rostock MAX Printer Frame
NEMESIS Air Delta v1 & v2 -Aluminum delta printers
Rostock MAX "KITT" - Tri-Force Frame
GRABER i3 "Slim"
RostockMAX v2 (Stock)
MAX METAL "ShortyMAX"
MAX METAL Rostock MAX Printer Frame
NEMESIS Air Delta v1 & v2 -Aluminum delta printers
Rostock MAX "KITT" - Tri-Force Frame
GRABER i3 "Slim"
Re: Issue with z height?
I was.
Re: Issue with z height?
Does anybody have any ideas why this has happened?
Re: Issue with z height?
what slicer and can you post a sample gcode?