Agisis Ultimate roStockMax v2 Tool Holder

[Agisis]

This tool holder was created because my desk was a mess of tools, tape, hotends, and glue sticks. It fits on the side of the roStock Max V2 with just two screws and holds everything you need. 4 pairs of pliers of various handle widths, 2 glue sticks holders, Digital Calipers, SeeMeCNC putty knife, Sharpie, Razor blades, Kapton Tape Holder, 4 Hot End Sizes that are labeled (.35mm, .4mm, .5mm, .7mm), Multiple slots for screw drivers.

http://repables.com/r/615

Enjoy!
(No, the skates don't come close to it even though it looks like they might).

[Tincho85]

cool, nice job!
my ocd approves

[Agisis]

Heh, I printed it three different times making modifications with each print. Getting the pliers and wrench to fit and stand at the correct angles took some crafting but it worked out. Should work with any pliers. The hotends should always fit even with goop all over them (I discovered that the hard way the first two times I printed it.) Overall, I'm satisfied and my desk is now clean.

[Eaglezsoar]

Great design and I am downloading the file. Thanks!