I've added this to the opening of Section 6:
"Note: Under no circumstances should you route the wires for the extruder down the same channel as any of the end-stop switch wires. Do. Not. EVER. The power flowing through the stepper motor wires will cause false triggering of the end-stop electronics."
I didn't show how to route the wiring down the /outside/ of the tower for my health.
*goes to find a kid to chase off his lawn*
g.
Leaning offset first print, what am i doing wrong?
Re: Leaning offset first print, what am i doing wrong?
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Re: Leaning offset first print, what am i doing wrong?
Dang. I just did this. Took me two days to figure out what was wrong - belt tightness? Nope. Skate wheels? Nope. Levelled platform, many times. Nope. STILL F'N LEANING. Found this thread. E Motor wire was running parallel to one of the end stop cables (part of a new rewire). Tore it out and routed it differently and now it's all gravy.