New Rostock Max V2 owner in NC

Brazz · Post by **Brazz** » Wed Dec 10, 2014 12:47 pm

Hi,

I just got done printing my layer fan shroud for my Rostock Max V2, also my first ever experience seeing, using, and building a 3D printer. Whew, what a relief that it actually works, haha.

I got this far without asking for assistance mainly due to how good the V2 and the accompanying build guide were, along with months of stalking 3D printer forums. That said, I probably could have done more research before hand, but I was also preoccupied with my quadcopter :p

Anyway, if anybody down here in the south needs help, let me know.

-Brazz

BenTheRighteous · Post by **BenTheRighteous** » Wed Dec 10, 2014 1:10 pm

quadcopter you say! Would you happen to be in the Raleigh area?

Brazz · Post by **Brazz** » Wed Dec 10, 2014 6:51 pm

I drive up to Chapel Hill quite often, I'm actually closer to Sanford. I have a kitbashed quadcopter with a 3DR APM at the helm.

0110-m-p · Post by **0110-m-p** » Wed Dec 10, 2014 10:29 pm

Nice to welcome another NC owner. I'm in Raleigh so if you ever need any help let me know.

craftymethod · Post by **craftymethod** » Wed Dec 10, 2014 11:48 pm

I have no idea where "NC" is lol

Brazz · Post by **Brazz** » Thu Dec 11, 2014 9:00 am

Well Crafty, then anonymity is alive and well on the internet.

*Edit: oh you're in Australia. Nice

0110-m-p · Post by **0110-m-p** » Thu Dec 11, 2014 9:33 am

craftymethod wrote:I have no idea where "NC" is lol

Right here....

Kevinvandeusen · Post by **Kevinvandeusen** » Sat Dec 13, 2014 6:37 pm

welcome Brazz. I am just down the road in upstate SC.

Welcome to the SeeMeCNC Community

New Rostock Max V2 owner in NC

New Rostock Max V2 owner in NC

Re: New Rostock Max V2 owner in NC

Re: New Rostock Max V2 owner in NC

Re: New Rostock Max V2 owner in NC

Re: New Rostock Max V2 owner in NC

Re: New Rostock Max V2 owner in NC

Re: New Rostock Max V2 owner in NC

Re: New Rostock Max V2 owner in NC