2 problems

[harley573]

No matter what I change those Z Max and printable settings to, nothing changes. I have the carriage at z=0. If I add length, I'd expect it to say z=whatever amount I added. It doesn't. It just stays at 0.

[harley573]

Okay, nevermind. I finally sent a G28 and that sent it home and reset the z count. Getting pretty close to dialing it in, I think. Hopefully I'll have a try at a print this afternoon. Thanks for all the help!

[harley573]

Now my extruder is acting funny. Could someone post a screenshot of the eeprom extruder settings?