Tower of Pi attempt

[cweiss]

I'll be trying to print the Tower of Pi http://www.thingiverse.com/thing:271769 Today (6/8).


Live stream from Dropcam: http://dropc.am/p/rostock

It's a 13hr print, here's to hoping it doesn't screw up!

[RAMTechRob]

Excellent clarity on that video. Looks good so far.

[cweiss]

This is just cruel and unusual punishment on the Bowden extruder. It has to retract a bit between each move between character legs. Sounds like a pneumatic nail gun. There's definitely a bad corner to the print, I'm guessing one of the cassettes is sloppy.

[Tinyhead]

Nice job. Looks like minimal stringing too.