Hello : KC from Indiana
Hello : KC from Indiana
Just purchased the Orion 3D printer, very impressed with it. But none the less I have a lot to learn with the development of being able to print something on my own seem very overwhelming at this point. Any suggestions or websites that does a step by step procedure of this from the drawing to slicing it and to putting on a sd card and to print?
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Hello : KC from Indiana
Download the 2nd edition of the Orion Users Manual, the last chapters tell you most of what you are looking for, the link is here: http://download.seemecnc.com/orion/Orio ... -2ndEd.pdfKConley wrote:Just purchased the Orion 3D printer, very impressed with it. But none the less I have a lot to learn with the development of being able to print something on my own seem very overwhelming at this point. Any suggestions or websites that does a step by step procedure of this from the drawing to slicing it and to putting on a sd card and to print?
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”