settings to change ABS to PLA

[whaleboy]

Hello...

I've printed the fan shrouds in ABS, and would like to change to PLA for future prints. What settings need to be changed? Temps need to change, but I'm not sure what else. I know there is a PLA settings file for Slic3r, but what about in Cura?

Thanks

-David

[guanu]

besides the temps, you will want to run the layer fan if you have it installed.. besides that, nope.. just temps and fan are the only changes for pla that I really do

Guanu

[whaleboy]

cool, thanks

-David