I have two (2) McMaster-Carr Heat-Resistant Borosilicate Glass plates up for sale - $10 each+s&h.
They are 1/8"x6"x6". I no longer need these because I went with a bigger glass plate for the Phebe I.
http://www.mcmaster.com/#8476K161
One has been used, but cleaned. Some tape residue remains on the back of the used plate from the double sided tape I used to hold this plate in place. no damage or chips to either glass plates.
No international shipping. PM me if you are interested.
McMaster-Carr Borosilicate Glass 1/8"x6"x6" $10+s&h
-
michaellatif
- Printmaster!
- Posts: 343
- Joined: Mon Mar 26, 2012 1:34 pm
- Location: RTP, NC
McMaster-Carr Borosilicate Glass 1/8"x6"x6" $10+s&h
Mike Latif
H-1 #3
H-1 #3
Re: McMaster-Carr Borosilicate Glass 1/8"x6"x6" $10+s&h
My bed is warped , if i tape glass to it will it still be level? Thinking of getting this.
-
michaellatif
- Printmaster!
- Posts: 343
- Joined: Mon Mar 26, 2012 1:34 pm
- Location: RTP, NC
Re: McMaster-Carr Borosilicate Glass 1/8"x6"x6" $10+s&h
Is the plastic bed warped? If so, glass won't help much. I had my plastic bed warp and the only solution was to get a 1/4" acrylic plate and replace the bed.
Mike Latif
H-1 #3
H-1 #3
Re: McMaster-Carr Borosilicate Glass 1/8"x6"x6" $10+s&h
yeah I though so 
Right now I'm printing on a piece of plexiglass on top of my bed but I can only print on certain parts of the bed, When you replaced it did you do anything about the bearings? I noticed some bearing assemblys only have one screw holding them on, do they twist at all ?
Right now I'm printing on a piece of plexiglass on top of my bed but I can only print on certain parts of the bed, When you replaced it did you do anything about the bearings? I noticed some bearing assemblys only have one screw holding them on, do they twist at all ?