EZStruder Top Mount

[texsc98]

Hey all, just wanted to throw this out there if you haven't seen it already... I designed & printed a top mount for the EZStruder which I've been using the past couple months, gotta say I LOVE it! It's super thin & lightweight, but sturdy enough to print ABS & 645 Nylon. Only took about an hour & a half to print...

http://www.thingiverse.com/thing:119198

And here's my top mount spool holder, another nice accessory. It used bearings for super low friction during rotation to increase the available torque of the stepper driving the filament!
http://www.thingiverse.com/thing:114717

[Eaglezsoar]

These are great. Thanks for posting these.