Welcome to the SeeMeCNC Community

I have just built a Rostock Kossel and am using ramps 1.4 for mother board. I am trying to use Repetier Max as my firmware, but when i change the mother board from 301 Rambo board to 33 Ramps 1.4 I get a compilation error. 'TEMP_BED_PIN' was not declared in this scope. I was told to look in pins.h ...

Yes, here it is.

#if ANALOG_INPUTS>0

Hello, I am still getting the same error code but only when i change the mother board from " 301 Rambo board" to "33 ramps 1.4 ". All other changes have been successful and have compiled correctly, Why will it not compile correctly when i choose the Ramps 1.4 ? Thanks for your patients and time, it ...

Just the typical adjustments, motherboard type etc.

foshon wrote:If your using SMCNC's RepMax do not change anything out of the box, just upload it.

I'm setting up the repetier max to be used with a Kossel printer, how can i use without making any changes ?

I re-downloaded repetier max and uploaded it to my ramps, and it uploaded correctly. When i go to make changes in Config.H for my specific machine a "Kossel" I'm getting the same error code on line 221 of Extruder .cpp .... .const uint8 osAnalogInputChannels[] PROGMEM = ANALOG_INPUT_CHANNELS; Any ...

@Polygonhell,

Thanks for your response, I downloaded repetier max from Seemecnc site about two months ago.
Should I re-download and try again ?

Aloha,

Jay Dub

Aloha,

I'm new to the world of 3D printers, i have just built a kossel. Anyone else on Maui ?

This is a newby question. When uploading repetier max i get an error code from extruder.cpp ,const uint8 osAnalogInputChannels[] PROGMEM = ANALOG_INPUT_CHANNELS;

'TEMP_BED_PIN' was not declared in this scope

I have no idea what to do ? Thanks in advance for any and all help !