Welcome to the SeeMeCNC Community

Hey there i've succesfully set up my dual extruder setup :D I measured the exact difference from E0 to zero in x and y, also from E1 zo zero in x and y direction. Calculated the steps and save it in the EEProm and also in the firmware and if i do an toolchange everything works fine and the prints ...

Hey Generic Default,
could you please upload the stl file for the mounting that would be outstanding
Thanks in advance!

Hey there, i've got my first (half) print out of my Rostock MAX :D i perform the hollow calibration cube and for the first print it looks really good i think :-) The edges warp a bit, but the layers and outer sides looking really good ;-) IMG20130714234134568 (Large).jpg The main problem was, that ...

Got the same problem
i fixed it (because i have no PTFE tube at home) by miss out the rubber from the bowden tube holder (is this the correct name?), so that the bowden tube holder pushes in the too short piece of PTFE tube into the nozzle

For the german guys in here i got the fuses from conrad: http://www.conrad.de/ce/de/product/5296 ... aege-T-5-A?. They are a tiny bit smaller than the original but they fit in the holder and hey it works

Oh there were a few things i don't thought about :o No i haven't replaced the stock power supply :roll: I ordered a few fuses, so i can test it with only one cartrige (12V/40W) per head and if it down't work i think i should do some replacements: -upgrade the power-supply and maybe -the fuse up to ...

Ok thanks Eaglezsoar,
i thought it would be useful to speed up the heating process
But i'll give it a try to run it with one if i receive the replacement of the fuse!

Great idea
i only think that it could be too fast for childs to follow the plane

Hey there, i build up a ROSTOCK MAX with two hotends and i use for each hotend two heat cartridges with 12V/40W. Then the fuse of the RAMBO is blown up after a few minutes of heating up to 190°C. Was that too much für the board or is it possible that i have a short somewhere? Is it better to put o ...

Really, no one in here from the south of germany?

kbob wrote:Start with Foshon's how-to.

http://forum.seemecnc.com/viewtopic.php?f=36&t=2152

Thanks for this really helpful link That helps a lot

Hey there,
i'm Michael from germany. I'm an engineer in mechatronics and i built up my first 3D-printer with the Rostock Max
Is there anyone from the south of germany e.g. Baden-Württemberg who has a Rostock Max yet?

Greetings

Michael

Hey September, thanks for the quick response, yes thats correct. The routing should be as follows: First Extruder: HotEnd: Extruder Heat 0 Extruder: E0 Thermistor: T0 Second Extruder: HotEnd: Extruder Heat 1 Extruder: E1 Thermistor: T1 Bed: Heater: Heated Bed Thermistor: T2 Yes i bought the Hot End ...

Hey there, could anybody help me with the add a struder kit? I have the normal Rostock MAX with the firmware from https://github.com/seemecnc/RepetierMAX/archive/master.zip Which changes and where i have to do in the firmware of the repetier host to get it to work with the normal connection like it ...