Welcome to the SeeMeCNC Community

Hi guys, I haven't been using my Rostock max v2 upgraded with a new fancy hotend with the probe thingy for probably a few weeks now cause I was building an enclosure for it. It's cold in my basement and I wanted to protect it a little better. So you guessed it I had to move it around a little bit ...

Hi Stimpy, Anything new on your end, I have the same issue where the hotEnd will dive hard into the plate. I thought that the idea with the upgrade was to prevent especially this from happening, so not sure... I also had error messages when sending configuration.h to the board did you get that too ...

Hi Gene,
So you are saying downgrade my IDE to be able to install this properly?
Thanks

Hi Guys, I just finished the upgrade of the hotEnd on my Rostock max V2 and here is my issue. After sending G29 in the terminal, the first part of the calibration seems to be going okay but then the HE goes back "Home" and come right down the middle and slams hard on the plate, goes back "Home" and ...

Hey @geneb, That's the first thing I've tried and they were all ok, but then by just moving wires around (in a pretty amteurish way I admit) to try to detect a short the LCD came back on. It looked like a major short was happening on my power input connector. I got the kit and that connector was not ...

Hi guys,

I've been printing with my Rostock Max v2 for few months now.
Starting a couple days ago prints would randomly stop in the middle.
Today the print failed again but the screen also went blank and the computer won't connect to the printer anymore.
Any ideas guys?

Thanks for your help