Welcome to the SeeMeCNC Community

Dumb Dumb on my part.
I put the M579 in config.g, but that was it, I didn't put the x, y, z, scaling in.
I assumed that when I entered and saved it would put those figures in.
Its all good now.

CarlJ

Hello, first off I don't usually post, I am able to find what I need by searching the forum, but not this time. Calibrating max v2 with duet3dwifi, I make adjustments for my x,y, axis, get them where I want them using the M579 command, save using M500. They stay till I power down. I did put the M501 ...

Hey, Thanks for the reply.
I hadn't noticed the lower case
Anyway I completely cleared eeprom and reloaded firmware.
Everything good now, Just keep my dobbers from trying different things.

CarlJ

Hello, I usually don't post, I am usually able to find the answer going thru the forums, but not this one. For some reason when I use the macro for bed center, x and y go toward the bed but z doesn't. G28 G0 z0 f3500 Macros for tower z,x,and y work correctly. I have homed all axis g28, did the ...

Hello, this might not be relevant, I had the same problem today. Was connected to Rostock max v2 thru matter control at the same time I was trying to compile and upload to Arduino. Found that I had to disconnect the printer from Matter Control program, than was able to upload new compile. Felt ...