Welcome to the SeeMeCNC Community

Bump, make an offer! I will consider anything remotely reasonable. Don't hesitate, you wont offend me.

Thanks,

Seth
ktmseth at gmail dot com

Hey All, I purchased, assembled and calibrated a Rostock Max as part of the indiegogo campaign last year. I have upgraded to the ONYX bed, tricklaser arms and the EZ-Struder. I have the top mount flat pack however i have not assembled or lengthened the wires to do so. I have not upgraded the hot end ...

Just about to begin another attempt with really slow infill, motor drivers turned down and slow print speeds to see if this cures the problem. i also raised the zero z height just a touch to ensure that no dragging is occurring as i noticed that part of the print the extrusion was "mushed" wider as ...

The driver values are at 195 as the stock setting, I moved to 180, no appreciable improvement in the problem, lower still? Whats acceptably low? Pulleys are all tight, verified no free play in cheapskates, belts are tight.

I am going to try the first few layers now running slower speeds and tightening the belt pulleys. This is a Rambo board, suggestions on settings for the motor drivers? When off, the print head can easily be move around, with no apparent binding, so I don't think that there is any mechanical ...

Okay so this is even more apparent in its severe detachment (perimeter from infil) No matter what settings, the infill refuses to contact the perimeter, this is generally a problem around 100% of a print. obviously, as you can see, its closer in some areas and more prevalent in others, the gcode ...

Thanks Polygonhell, ill try the belt tightening route and see how that works. I may also experiment with kiss slicer as well if eliminating backlash does not solve my problems.

--Seth

Hey All, I was a terrible customer and completely ignored my build thread in my excitement to get teh Max up and running, after some teething problems with calibrations and finally zeroing in on what i consider at least passable quality prints, i have run into a problem. larger prints are ...

Hey All, Considering my recent contribution to the campaign for the wood kit (complete) and the dial indicator holder, I thought I would claim a preemptive build log slot. I plan on initially using the printer for a project for a design class, and thereafter integrating it into a few ideas I have ...