Welcome to the SeeMeCNC Community

Dear Polygonhell & bvandiepenbos,

Thanks for that information. I will give it a go.

Any thoughts on why Repetier gives Z axis values in red? Is this because I haven't completed proper calibration ?
Or is this just normal behavior ?

Thanks again, I am sure I will be back in touch

Rudero

A small update to this problem and some more questions: I have worked out that this is more an issue of my arduino configuration.h settings not being sent to EEPROM settings. When I manually change the maximum Z-axis length in EEPROM to above 300, the G0 Z300 F3500 command works (i.e. it sends the ...

Dear gestalt73, see below for my configuration.h : I believe the part you referred to is the same in mine. /* This file is part of Repetier-Firmware. Repetier-Firmware is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the ...

Dear all, I have just upgraded the firmware for my Rostock MAX v1 to v0.91. I have a RAMBo v1.1b board. I am trying to go through the software setup and calibration procedure in the Manual (v2: http://download.seemecnc.com/rostockmax/Rostock-MAX-Assembly-Guide.pdf) and got as far as homing using ...

Hi Polygonhell, Thanks for your reply. Yes it runs firmware v0.83 from what I can gather. The only instructions on how to upgrade the firmware I have found so far are here: http://reprap.org/wiki/Rostock_MAX#Software_and_Setup But this video "Installing Youtube" (under the Software and Setup heading ...

Hi everyone, I am a biologist/physiologist with my own laboratory and always in need of improving/adding to experimental rigs or other setups to make my or my students' lives easier. I am new to 3D printing and just acquired a (built) Rostock MAX v1 (RAMBo 1.1b) and in the process of setting up ...