Welcome to the SeeMeCNC Community

Can some post the last screen shots of the config info?

Thanks.........Ken

The print finished. No stoping half way. I used the same gcode I was using before I upgraded to the new firmware.
I upgraded to 0.91.
I would like thank those who gave suggestions.

Thanks....Ken

I just finished install the las test firm ware and re-calibrating. Started the printer up to try again with the same file.
Will know something in about 4 hours if I have the same problem. Or success in 6+ hours.
Stay tuned

Ken

Repetier 0.83seeme

It's a 7 hour print that stops about halfway every time. 4 trys, change the layer thickness from .4 to .2 then to .21 . Tried 2 different versions of Slic3r. same results Tried print from SD card and pc. SD card is a class 10. generated by Slic3r 1.0.0 on 2014-04-18 at 12:37:17 ; layer_height = .21 ...

That's the one. The Assembly Guide shows #15293.

Thanks.............Ken

I went to Thingverse to download #15293 test cube and it shows a thermo tube instead. Has the test cube been moved?

Ken

New to 3D printing. Purchased a Rostock Max last month. At the calibration stage in the build. May do a test print tonight if everything goes well.