Page 1 of 1
Someone should start a club...
Posted: Mon Jan 25, 2016 6:02 pm
by barry99705
Re: Someone should start a club...
Posted: Mon Jan 25, 2016 6:25 pm
by mhackney
PEI!
Re: Someone should start a club...
Posted: Mon Jan 25, 2016 7:12 pm
by ccavanaugh
mhackney wrote:PEI!
Plastic
Emerges
Inside?... Sorry, you can take away my joke card now.
Re: Someone should start a club...
Posted: Mon Jan 25, 2016 7:31 pm
by Outsider
Re: Someone should start a club...
Posted: Mon Jan 25, 2016 7:32 pm
by barry99705
Well after some dremeling, I got the effector platform free. Tried using my propane shop heater to melt some of the pla, but I think it's toast. Will have to make a plaque for it.
[img]
https://lh3.googleusercontent.com/-D4ym ... 191908.jpg[/img]
Hey, where's the best place to order an E3d?
Re: Someone should start a club...
Posted: Mon Jan 25, 2016 7:45 pm
by IMBoring25
In the US I think Filastruder would be hard to beat.
Re: Someone should start a club...
Posted: Mon Jan 25, 2016 10:48 pm
by Eric
If you haven't damaged the wires and the heater and thermistor still work, I bet you could bring the thing up to temperature and most of that would flow off the hotend.
Re: Someone should start a club...
Posted: Tue Jan 26, 2016 8:51 pm
by barry99705
Found matterhackers has the best price for an e3d. They have free shipping in the US.
Re: Someone should start a club...
Posted: Tue Jan 26, 2016 10:59 pm
by IMBoring25
They're higher than Filastruder...
Re: Someone should start a club...
Posted: Wed Jan 27, 2016 7:28 am
by barry99705
IMBoring25 wrote:They're higher than Filastruder...
After shipping it cost more than matterhackers to my house. With shipping it's $89.99, matterhackers is $83.00.