Welcome to the SeeMeCNC Community

Bout time I get acquainted with the community. Greetings!

Ok, back to printing.

Colleague at work inspired me to pull the trigger on getting a 3D printer. Scouring the interwebs researching various options, I ordered the Rostock Max v2 back in Nov 2015 along with a ton of plastic. He and I traveled to SeeMeCNC and picked the goods up after devouring a couple tacos at Taco Time just down the road. Fast-forwarding to today, the printer is seldom off unless I'm doing part upgrades, etc... Love it!

As for my background, just perform a search for blitzjon - I'm pretty much everywhere.

And you can keep your tacos warm on the heated bed
I'll admit to doing this more than once.

Gotta watch the grease on the bed causes prints to stick funny, but if it ain't greasy - it ain't a good Taco.

(words spoken while recovering from stomach surgery)

Welcome to the forum, bLiTzJoN.
Thank you for purchasing the Rostock Max V2 from SeeMeCNC.
It's great that you successfully print a lot of stuff, maybe you could send us a picture of your completed printer.
Happy Printing!