Welcome to the SeeMeCNC Community

Hello all.

I was thinking about create a troubleshooting guide with some causes/way to correct this but by searching I found this one which can be usefull for begin to print.

https://www.simplify3d.com/support/prin ... to-the-bed

Hope this will help a few of you.

Have a nice day.

Morgan

This one is good, too.

http://support.3dverkstan.se/article/23 ... ting-guide

Between the two of them, most issues are covered.

Thank you both for those links.

Thanks for posting the links, I'm sure that our members could put those to good use.