Page 1 of 1
slic3r not working since update
Posted: Tue Nov 03, 2015 2:26 pm
by Right to Make
I have used slic3r in the past within mattercontrol and it had worked just fine, but I recently updated to mattercontrol 1.4 and now it always comes up with a slicing error. Please review your settings. It doesn't matter which settings, nothing can work. Both matterslice and cura work as expected. I was wondering if anyone is experiencing this with mattercontrol.?
Re: slic3r not working since update
Posted: Wed Nov 04, 2015 2:18 am
by jason128
yep- seems a very common problem. ended up rolling back to the previous version
Re: slic3r not working since update
Posted: Wed Nov 04, 2015 8:55 am
by Right to Make
Ok, that's what ill do. Thanks for that.
Re: slic3r not working since update
Posted: Wed Nov 04, 2015 1:02 pm
by Nath5
I am having the same problem. I now use the standalone slic3r do create the gcode and then load that in matter control.