Page 1 of 1
E3D V6 thermistor swap out
Posted: Tue Oct 06, 2015 5:51 pm
by stonewater
as opposed to using the thermistor shipped with the V6 any reason not to use the thermistor that came with my stock hot end, I have a few spares.....
Tom C
Re: E3D V6 thermistor swap out
Posted: Wed Oct 07, 2015 10:32 pm
by Xenocrates
not that I can think of, although I would use E3D's fiberglass sleeving on the seemeCNC thermistors so you don't add PTFE back into your all metal hotend. the sleeving may degrade after a few thermistor swaps if you don't get more. Only concern would be making sure the sensor number is right, which I'm sure you can manage. I prefer the PT100 sensors myself, although if you want to use the volcano with them it's a hassle.