Welcome to the SeeMeCNC Community

I am about 65% complete with my build. Slowly during my available time. Really looking forward to getting this thing fired up.
My gateway printer was a Micro3D from Kickstarter. After using it for a while I was ready to jump in feet first to a more comprehensive printer. My wife looks at me like I am crazy...having fun is the important part right?

I am also an architect and use Autodesk Revit everyday. It does a nice job with .stl exports. Now that I will have access to a much larger build volume hopefully I can print out some decent architecture pieces.

Jon

architectjon wrote:I am about 65% complete with my build. Slowly during my available time. Really looking forward to getting this thing fired up.
My gateway printer was a Micro3D from Kickstarter. After using it for a while I was ready to jump in feet first to a more comprehensive printer. My wife looks at me like I am crazy...having fun is the important part right?

I am also an architect and use Autodesk Revit everyday. It does a nice job with .stl exports. Now that I will have access to a much larger build volume hopefully I can print out some decent architecture pieces.

Jon

Hi Jon and welcome to the Forum!
Thanks for purchasing the Rostock Max V2 and we wish you a great build! Pictures of your printer would be appreciated
if you get the time to upload them to us. Having fun is the important part and I do hope that you are having fun!
Have a great build!!