Welcome to the SeeMeCNC Community

Hello everybody.

Just registered to the forum. I am real newb rgd 3D printing. Thats why I seek as much knowledge as possible. I see this forum is strong delta printers oriented and I am a bit worried to admit my printer is carthesian one. I purchased Prusa i3 kit from Mr Prusa himself about two months ago.

I am able to print simple objects that have little overhang. I designed few things myself already and posted them on TD and YM:
http://www.thingiverse.com/Karlosek/about

I am looking forward to improving my printing abilities and I am very tempted to dive in the world of delta printers.

This forum seems full of very friendly and helpful people as far as I can tell from browsing it before I registered.

Welcome! Yeah, we're a good group here. Even our occasional little spats are fun and lively!

If you haven't, you might read the posts linked in my signature. They are not delta specific and have helped a lot of folks get much better results.

Cheers,
Michael

Cheers to you Michael!

I went through your post about Successful and great printers briefly before I registered. Your post was the last impulse for me to register.