some Gcode questions
Posted: Mon May 25, 2015 11:17 am
not sure where to post this, but anyway I have a couple of questions
I would like to actually learn a bit about programming, things like how ho assemble a good start and end Gcode for specific things like bed heat before hot end heat. so I was wondering about where to actually get a good tutorial on how to assemble the Gcode in such a way as to not cause problems with a print and to be able to read it a bit better.
second thing would be how to learn arduino.... been to the reprap site but most assume you actually have programming experience, and I would like something for a complete noob. I am kinda the why it works and then how it works learner..... as in why is the code in the order its in, things like that, real basic. any suggestions appreciated.
Tom C
I would like to actually learn a bit about programming, things like how ho assemble a good start and end Gcode for specific things like bed heat before hot end heat. so I was wondering about where to actually get a good tutorial on how to assemble the Gcode in such a way as to not cause problems with a print and to be able to read it a bit better.
second thing would be how to learn arduino.... been to the reprap site but most assume you actually have programming experience, and I would like something for a complete noob. I am kinda the why it works and then how it works learner..... as in why is the code in the order its in, things like that, real basic. any suggestions appreciated.
Tom C