Thin edge printing as dashed line
Posted: Mon Apr 27, 2015 12:39 pm
Hi everyone,
I'm having an issue successfully printing a channel on a specific part that has very thin walls. The channel is formed by two concentric arcs which form walls that are about .5mm thick. The issue I'm having is that one wall prints just fine, and the other is printing as a dashed line. Does anyone have any advice on how to solve this? I'm very new to this.
Thanks!
I'm having an issue successfully printing a channel on a specific part that has very thin walls. The channel is formed by two concentric arcs which form walls that are about .5mm thick. The issue I'm having is that one wall prints just fine, and the other is printing as a dashed line. Does anyone have any advice on how to solve this? I'm very new to this.
Thanks!