got my own xmas present..
Posted: Sun Jan 04, 2015 7:51 pm
Picked up the max v2 and it finally got here Friday. Been working on it all day yesterday and today. I have two questions so far..
Can i print new tower and vertical supports once i get the machine working? I didn't completely wreck them just tightened a few to many spins. The directions said be careful but i didn't realize how easy it was.
Also I installed the wrong leveling screws on the bottom instead of the wood screws. By the time i noticed all i could to without removing everything was just screw them in from the outside. Should this be ok for a while? All axis are currently level along with the top so they seem to be doing their job. If I reprint new supports this will also be something i fix as well.
Right now I'm getting the skates togethers so i doubt I'll finish my build by tonight.. Maybe Monday or Tuesday.
Can i print new tower and vertical supports once i get the machine working? I didn't completely wreck them just tightened a few to many spins. The directions said be careful but i didn't realize how easy it was.
Also I installed the wrong leveling screws on the bottom instead of the wood screws. By the time i noticed all i could to without removing everything was just screw them in from the outside. Should this be ok for a while? All axis are currently level along with the top so they seem to be doing their job. If I reprint new supports this will also be something i fix as well.
Right now I'm getting the skates togethers so i doubt I'll finish my build by tonight.. Maybe Monday or Tuesday.