Page 1 of 1
Test prints
Posted: Fri Nov 07, 2014 9:47 am
by dunginhawk
Does anyone out there have a nice test print that i can run each time i tweak, to get uniform perfection .
i havent seen one out there.
thanks
Re: Test prints
Posted: Fri Nov 07, 2014 10:04 am
by Jimustanguitar
Re: Test prints
Posted: Fri Nov 07, 2014 10:05 am
by rpress
Here is one for bed calibration. Judging from your other thread this should help you out.
http://www.thingiverse.com/thing:50505
Re: Test prints
Posted: Fri Nov 07, 2014 12:12 pm
by dunginhawk
what would be a good variance here?
im getting close to seeing .31 -.35 everywhere on the bed.. is that close enough?
