Page 1 of 1
old man with new toy
Posted: Thu Jun 05, 2014 10:28 pm
by beglylw
Hello all, just purchased a Orion. many years experience with RP equipment purchased and ran many of the different processes Z- corp powder based, Stratasys FDM from their first 150 to the Titans. SLS (selective laser sinter) from DTM (now 3-D Systems), Stereo-lithography (SLA) 7000 3D Systems. Unfortunately the company where I worked in R&D went south and I gained an early retirement. Hoping this new Delta will give me an opportunity to keep designing and "rapid Prototyping" new toys.
-Sunny at Sunny Lea CNC.
Re: old man with new toy
Posted: Fri Jun 06, 2014 7:11 am
by Eaglezsoar
Welcome to the Forum!
You have quite a background and can probably help some of our users.
If you have questions or problems just drop us a message.\
Enjoy your new Orion and Happy Printing!
Re: old man with new toy
Posted: Fri Jun 06, 2014 8:09 am
by Jimustanguitar
What a great asset to the community, welcome!
Re: old man with new toy
Posted: Fri Jun 06, 2014 10:23 am
by Max
Old is relative here. You might end up being one of the younger ones.
Re: old man with new toy
Posted: Fri Jun 06, 2014 7:57 pm
by McSlappy
Yes, don't assume you're old just yet
Re: old man with new toy
Posted: Fri Jun 06, 2014 9:19 pm
by Eaglezsoar
McSlappy wrote:Yes, don't assume you're old just yet
Yea, you can start assuming it when you are older than dirt like me.
Re: old man with new toy
Posted: Fri Jun 06, 2014 10:01 pm
by McSlappy
I would never have believed it until I saw the happy snap of you and the SeeMe boys
There's hope for me yet - if your mind can be as quick as anyone here, perhaps I will be intelligent also when I'm older.