I have a Makerbot style printer and am using a Mega/Ramps combination to run it.
I would love to build a Rostock and my question is can I use this same combination? if so what firmware will I need? and if not what boards and firmware must I buy?
Electronics for the Rostock
-
Tony Woollacott
- Plasticator
- Posts: 10
- Joined: Wed Apr 04, 2012 4:45 am
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Electronics for the Rostock
The Mega/Ramps will run the Rostock Max, the only changes would be to choose the Ramps instead of the Rambo in the firmware.Tony Woollacott wrote:I have a Makerbot style printer and am using a Mega/Ramps combination to run it.
I would love to build a Rostock and my question is can I use this same combination? if so what firmware will I need? and if not what boards and firmware must I buy?
You must also realize that you will not have the digipots in the firmware anymore and all driver current changes would have to be made by hand.
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”