Welcome to the SeeMeCNC Community

... and mere minutes away from Matter Hackers, the fine folks that program MatterControl.

Built a Rostock MAX last month. Having a few issues with settings, but the printer itself if working great!

EdwardP wrote:... and mere minutes away from Matter Hackers, the fine folks that program MatterControl.

Built a Rostock MAX last month. Having a few issues with settings, but the printer itself if working great!

Welcome to the forum!
At least you don't have to go far to get filament form Matterhackers!
If you ever need help just drop us a message, it's amazing that you built the Max without a single question!
I would call that a great job! Enjoy your new Max and Happy Printing!

Welcome!!! Looking forward to seeing your posts! I'm just south of you!

Eaglezsoar wrote:

EdwardP wrote:If you ever need help just drop us a message, it's amazing that you built the Max without a single question!
I would call that a great job! Enjoy your new Max and Happy Printing!

Thank-you. It was a bit of a struggle, however. I only needed one new tool (better crimper), but had most of the supplies (even Kapton tape) and all of the skills (former electronics industry engineer). I was amazed that it took me 30 hours.

[Edited for clarity]

Welcome to the club sir. Also a local OC rostockMAX connoisseur.

Let me know if you have any issues that require local diagnosis, but as Eagle said, impressive you did it all so quickly!

Welcome from another new guy also in the OC, the mouses backyard here.
Playing with the new t-glas on my orion.

Thanks for all the compliments. We should get together for the responsible consumption of beverages sometime.

I'm even ok with irresponsible amounts.