Welcome to the SeeMeCNC Community

Up to page 42 on my Rostock V2...

Quick question, what's a good filament to start with?

Thanks!

Hi, welcome to the forum!
I have found ABS easier to print with for beginning users,
did a spool of filament come with your printer? If so, that spool
would be the best to start with. This forum is huge and it is full
of good tips on filament selection etc. When you find the time I
would recommend searching through the forum and reading some
of the topics. Wishing you a great build!

Nope, but with the Rostock, I guess it wasn't included. I bought a roll of ABS from Gizmo Dorks (fairly cheap, looks to be good quality). Thanks!