Welcome to the SeeMeCNC Community

I am honoured to be a new member at such a extensive and well-moderated forum.

I have one question that someone might be able to answer and is;

Is the bolt and nuts on the machines sold on the SeemeCNC homepage fully metric or Imperial? I have not gotten my machine yet and was just wondering. Spare-parts and all.

Welcome to the forum!

I believe that most of the hardware is imperial. There might be a metric screw here and there (aluminum t-slot bolts?), but 90% of the machine is made with 6-32 screws of various lengths.

Check out the "Official Docs" section of the forum. Gene has a complete parts list at the beginning of the manual for each machine.

Thanks you so much.