Welcome to the SeeMeCNC Community

Hey all!

I just purchased a ROSTOCK MAX kit, so I figured I'd join the forum so I can use all your great ideas and advice! I am an R&D technician, and I work with lasers (ie; LASERMAN). Currently I am working on a machine used for cataract surgery. I am used to integrating motors, optics, cameras, sensors, lasers, etc. So I should be able to handle the build. I have been in the business long enough to know that the secret is to use the knowledge available - so I will be reading a lot of the posts on this site. Thanks in advance for all the good info!

LASERMAN wrote:Hey all!

I just purchased a ROSTOCK MAX kit, so I figured I'd join the forum so I can use all your great ideas and advice! I am an R&D technician, and I work with lasers (ie; LASERMAN). Currently I am working on a machine used for cataract surgery. I am used to integrating motors, optics, cameras, sensors, lasers, etc. So I should be able to handle the build. I have been in the business long enough to know that the secret is to use the knowledge available - so I will be reading a lot of the posts on this site. Thanks in advance for all the good info!

Welcome to the Forum!
If you haven't already please download the latest assembly manual located here: http://www.geneb.org/rostock-max/Rostoc ... -Guide.pdf
As you start and continue your build we would be happy to help you by answering any question you may have.
Happy Printing!