Page 1 of 1
Hello fro St. Louis, MO
Posted: Sun Feb 16, 2014 2:39 pm
by cdarrellg
Hey everyone. I just purchased the Rostock Max kit and this will be my first 3D printer. It should be here in a few. I have to admit, I'm rather new to 3D printing. But for several months now, I've been doing a fair amount of reading. I'm looking forward to learning all I can about it once it gets here and I get it all dialed in.
Re: Hello fro St. Louis, MO
Posted: Sun Feb 16, 2014 3:10 pm
by townsend
Welcome! We're both in the same boat - I ordered my machine a day or two ago and I'm expecting it in a few days too.
Re: Hello fro St. Louis, MO
Posted: Sun Feb 16, 2014 4:17 pm
by Eaglezsoar
cdarrellg wrote:Hey everyone. I just purchased the Rostock Max kit and this will be my first 3D printer. It should be here in a few. I have to admit, I'm rather new to 3D printing. But for several months now, I've been doing a fair amount of reading. I'm looking forward to learning all I can about it once it gets here and I get it all dialed in.
Welcome to the Forum!
If you haven't already please download the latest assembly manual located here:
http://www.geneb.org/rostock-max/Rostoc ... -Guide.pdf
As you start and continue your build we would be happy to help you by answering any question you may have.
Happy Printing!