Page 1 of 1
Preconfigured Settings for Orion
Posted: Wed Feb 12, 2014 8:16 pm
by makerguy564
Hello. There's a link for preconfigured settings in the 2nd Edition Orion Manual AND there's a link for preconfigured settings on the SeeMeCNC Downloads page. Which one should I use? There's some major differences between the two... Thanks!
Re: Preconfigured Settings for Orion
Posted: Wed Feb 12, 2014 8:40 pm
by johnoly99
makerguy,
You can use either one. The one's on the website's download page i posted earlier today. Those are the settings that i print with on all of my machines at the shop. They are working really really nice! the biggest diff. is prob. the extrusion widths being manually specified. Those settings are giving the best general purpose settings prints. I've thrown almost everything from super small parts up to max build volume prints at them, with only tweaking the infill percentages
Re: Preconfigured Settings for Orion
Posted: Fri Feb 14, 2014 10:44 am
by makerguy564
Yep! The config off the download page works awesome! Thanks!!