Page 1 of 1

Up and Not running

Posted: Mon Feb 03, 2014 11:41 pm
by neurascenic
First, the LCD Isn't lit up. I will search for that in a moment.
Rambo has power, and there is at least some communication with the r-Host.




Second, when I try to. Do an M119 It does nothing. But there appears to be a command suck in the que just prior.


Gives me the installed firmware, then
Printed filament:0.00 m
Printing time: 0days 0 hours 0 min

Nothing more

What am I missing?

Re: Up and Not running

Posted: Mon Feb 03, 2014 11:46 pm
by neurascenic
Oop. Just performed a reset on the Rambo' s. Board, and now I can send the gCode commands

Gotta hunt for the LCD ISSUE.

Re: Up and Not running

Posted: Mon Feb 03, 2014 11:59 pm
by neurascenic
Neurascenic = Bonehead Figured the LCD out.

I read the instructions, but my brain ostensibly only processed the picture. My wires point down instead of up...

Bone Head!

Re: Up and Not running

Posted: Tue Feb 04, 2014 12:03 am
by DavidF
neurascenic wrote:Neurascenic = Bonehead Figured the LCD out.

I read the instructions, but my brain ostensibly only processed the picture. My wires point down instead of up...

Bone Head!
ROTFLMAO...yep been there done that....first print tonight??

Re: Up and Not running

Posted: Tue Feb 04, 2014 1:44 am
by neurascenic
Not tonight. Ran the Tests, and after my initial BH moment was over, all worked as intended.

Tomorrow night, Install .91 firmware, and Calibrate.

If only I didn't have to get up in 5.5 hrs I'd be at it.

Gene read me like a book though... I was pretty giddy and dancing around with from my first G28!


I am so.... Excited for tomorrow night!