Welcome to the SeeMeCNC Community

Posted: **Wed Jan 08, 2014 5:38 pm**

I finally did something right and managed to get signed in. I created my account while my BYOL RMAX was still being lost by UPS. They must have paid for a new one because another one showed up a week later.
Thanks Seemecnc for taking care of that.
I also did a lot of reading of other peoples build. Thank you everyone who took the time to do that.
Special thanks to Gene Buckle who answered my emails when I could not get on the boards with questions. Your manual made building my RMAX a breeze.

I built a tricklaser.com Tri-Force with custom Traxxas ball end rods. I will post some pictures as soon as I figure out how to.

Posted: **Wed Jan 08, 2014 5:57 pm**

Welcome to the Forum. We would love to see pictures. Send them as an attachment, they should work.
We are here to answer your questions and help with any problems. Happy Printing!

Posted: **Sat Jan 11, 2014 5:04 pm**

Currently working on Venus de milo. She will be 19 inches tall when done.

Posted: **Sat Jan 11, 2014 5:41 pm**

MrPTrog wrote:Currently working on Venus de milo. She will be 19 inches tall when done.

That looks nice, send a picture when you get her finished.

Posted: **Fri Jan 17, 2014 6:11 am**

Welcome and nice finish on that! Do post pics and specs when you are ready!

Welcome to the SeeMeCNC Community

Hello all and thank you!

Hello all and thank you!

Re: Hello all and thank you!

Re: Hello all and thank you!

Re: Hello all and thank you!

Re: Hello all and thank you!