Welcome to the SeeMeCNC Community

Wasn't sure what kind of knob I wanted, so I selected a few that I found on thingiverse...

[img]http://farm4.staticflickr.com/3791/1128 ... d175_b.jpg[/img]

[img]http://farm3.staticflickr.com/2834/1128 ... b770_b.jpg[/img]

And the chosen knob...

[img]http://farm8.staticflickr.com/7376/1128 ... 23a7_b.jpg[/img]

I also printed two of the rod clips and purchased a piece of 3/8" aluminum rod from Lowe's to guide my wires down from the top of the printer...

[img]http://farm4.staticflickr.com/3727/1128 ... 4d76_b.jpg[/img]

This was also my first time using a glue stick for the bed instead of blue painters tape. Had to re-calibrate my z-axis, but using the glue stick is so much easier than aligning strips of tape...glad I switched.

0110-m-p wrote:This was also my first time using a glue stick for the bed instead of blue painters tape. Had to re-calibrate my z-axis, but using the glue stick is so much easier than aligning strips of tape...glad I switched.

What are you using PLA or ABS?

PLA until tomorrow when my first spool of ABS arrives.

Nice Knobs!!! Just make sure you can push that knob on the LCD in ... The following is said in a very very quiet voice - "it is also a button"