Trouble configuring Artemis 300 (December 2021)
Posted: Sun Dec 12, 2021 3:05 pm
I had an issue with my hot end and sent it to SeeMeCNC for maintenance. It was just delivered back to me. I Believe they updated the firmware. I am trying to connect it to wifi but when I enter the following commands as it states to do in the guide (M552 S0, M587 S"NetWorkSSID" P"password", M552 S1) the response I am getting from the printer is "Wifi reported error: no known networks found." does anyone have any suggestions? Is there a new way to connect the Artemis to wifi that I am not aware of? let me know. Thanks.