Welcome to the SeeMeCNC Community

Have a look around and join today!
https://forum.seemecnc.com/

SE300 Heater Power Problem

https://forum.seemecnc.com/viewtopic.php?t=12939

Page 1 of 1

SE300 Heater Power Problem

Posted: Tue Nov 03, 2020 6:41 pm
by ROvermeyer
I built a Max V3, which I upgraded to a V3.2. The SE300 had the hotend power problem where it overheated the power connector for the hotend heater. I installed the SE300 Power Connector Upgrade Kit to fix this problem. I am again having hotend power problems and I found that the new power connector on the circuit board is broken, see attached photo. I see that SEEMECNC no longer sells the upgrade kit. Does anyone know what the part number of the 2 pin Molex receptcale is?

Thanks

20201103_140419.jpg
20201103_140419.jpg (272.69 KiB) Viewed 6095 times

Re: SE300 Heater Power Problem

Posted: Wed Nov 04, 2020 8:38 am
by geneb
Contact support, they can help you out with that.

g.

Re: SE300 Heater Power Problem

Posted: Wed Nov 04, 2020 9:57 am
by ROvermeyer
geneb,

I posted this here and contacted support, support has responded.

Thanks.

Bob O.
All times are UTC-04:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited