Page 1 of 1
viki lcd with rambo
Posted: Tue Feb 26, 2013 5:09 pm
by cambo3d
Is anyone using the viki lcd with the rambo?
http://www.panucatt.com/product_p/vikilcd.htm
Looking at the board and the lcd panel they both have I2C connections. Seems a bit more simplified for wiring purposes with just 4 wires vs the reprap discount lcd 20+ wires that you have to rewire.
has anyone successfully implemented it? I have one on order.
Re: viki lcd with rambo
Posted: Thu Feb 28, 2013 11:28 pm
by cambo3d
I guess no one has done this with the rambo board but looking at the marlin firmware it seems to support it. I know this works for the ramps arduino marlin combo. So i'm thinking it should work the same way.
So I'm going to give it a try and report once I get everything.
Re: viki lcd with rambo
Posted: Thu Jan 15, 2015 9:56 pm
by Nylocke
This is quite an old thread, but have you had success with the Viki/RAMBo combo? School got a Viki/X5 Mini combo and I don't want to use an Ardino to get the thing working, but I have a RAMBo I plan to use for another printer for school that could work nicely with it.
Re: viki lcd with rambo
Posted: Mon Nov 16, 2015 5:30 pm
by Eaglezsoar
Nylocke wrote:This is quite an old thread, but have you had success with the Viki/RAMBo combo? School got a Viki/X5 Mini combo and I don't want to use an Ardino to get the thing working, but I have a RAMBo I plan to use for another printer for school that could work nicely with it.
I would like to know if anyone has had success with the Viki/Rambo combo.